Renesas EK-RA6M4
Note
This demo is based on a 5MP camera
Deploy development environment
Refer to the link to deploy your environment Quick start
Hardware Requirements
EK-RA6M4 board
Micro USB device cable
USB to serial port module
Software Requirements
Windows ® 10 operating system
USB Serial Drivers (included in Windows 10)
SEGGER J-Link ® USB drivers
FSP
Note
The FSP, J-Link USB drivers, and e 2 studio are bundled in a downloadable platform installer available on the FSP webpage at renesas.com/ra/fsp. New users are recommended to use the Quick Install option provided in the installation wizard, to minimize the amount of manual configuration needed
Hardware Connection
Pmod 1 Connector
Pmod 1 Connector |
EK-RA6M4 |
Mega Camera |
|
|---|---|---|---|
Pin |
Description |
Signal/Bus |
Pin |
J26-1 |
CS |
P301 (SSLA2/CTS_RTS9) |
CS |
J26-2 |
MOSI |
P203 (MOSIA/TXD9) |
MOSI |
J26-3 |
MISO |
P202 (MISOA/RXD9) |
MISO |
J26-4 |
SCK |
P204 (RSPCKA/SCK9) |
SCK |
J26-5 |
GND |
GND |
GND |
J26-6 |
VCC |
VCC |
VCC |
J26-7 |
GPIO / INT (slave to master) |
P008 (IRQ12-DS) |
x |
J26-8 |
GPIO / RESET (master to slave) |
P311 |
x |
J26-9 |
GPIO / CS2 |
P312 |
x |
J26-10 |
GPIO / CS3 |
P313 |
x |
J26-11 |
GND |
GND |
x |
J26-12 |
VCC |
+3.3V/+5V |
x |
Serial Connector
EK-RA6M4 |
USB to Serial |
P410 |
TX |
P411 |
RX |
GND |
GND |
Arducam mega full features preview
