Renesas EK-RA6M4 ================== .. note:: This demo is based on a 5MP camera Deploy development environment ******************************* Refer to the link to deploy your environment `Quick start `_ Hardware Requirements ********************** - EK-RA6M4 board - Micro USB device cable - USB to serial port module Software Requirements *********************** - Windows ® 10 operating system - USB Serial Drivers (included in Windows 10) - `Arducam Mega GUI `_ - `e2 studio IDE `_ - SEGGER J-Link ® USB drivers - FSP .. note:: The FSP, J-Link USB drivers, and e 2 studio are bundled in a downloadable platform installer available on the FSP webpage at renesas.com/ra/fsp. New users are recommended to use the Quick Install option provided in the installation wizard, to minimize the amount of manual configuration needed Hardware Connection ******************** .. image:: /_static/images/renesas/hardware_connect.jpg Pmod 1 Connector ~~~~~~~~~~~~~~~~~~ +-------------------+--------------------------------+-----------------------+-------------+ | Pmod 1 Connector | | EK-RA6M4 | Mega Camera | +===================+================================+=======================+=============+ | Pin | Description | Signal/Bus | Pin | +-------------------+--------------------------------+-----------------------+-------------+ | J26-1 | CS | P301 (SSLA2/CTS_RTS9) | CS | +-------------------+--------------------------------+-----------------------+-------------+ | J26-2 | MOSI | P203 (MOSIA/TXD9) | MOSI | +-------------------+--------------------------------+-----------------------+-------------+ | J26-3 | MISO | P202 (MISOA/RXD9) | MISO | +-------------------+--------------------------------+-----------------------+-------------+ | J26-4 | SCK | P204 (RSPCKA/SCK9) | SCK | +-------------------+--------------------------------+-----------------------+-------------+ | J26-5 | GND | GND | GND | +-------------------+--------------------------------+-----------------------+-------------+ | J26-6 | VCC | VCC | VCC | +-------------------+--------------------------------+-----------------------+-------------+ | J26-7 | GPIO / INT (slave to master) | P008 (IRQ12-DS) | x | +-------------------+--------------------------------+-----------------------+-------------+ | J26-8 | GPIO / RESET (master to slave) | P311 | x | +-------------------+--------------------------------+-----------------------+-------------+ | J26-9 | GPIO / CS2 | P312 | x | +-------------------+--------------------------------+-----------------------+-------------+ | J26-10 | GPIO / CS3 | P313 | x | +-------------------+--------------------------------+-----------------------+-------------+ | J26-11 | GND | GND | x | +-------------------+--------------------------------+-----------------------+-------------+ | J26-12 | VCC | +3.3V/+5V | x | +-------------------+--------------------------------+-----------------------+-------------+ Serial Connector ********************* ========== =============== EK-RA6M4 USB to Serial ---------- --------------- P410 TX ---------- --------------- P411 RX ---------- --------------- GND GND ========== =============== Arducam mega full features preview *********************************** .. image:: /_static/images/renesas/renesas_mega_demo.gif