I’m trying to capture frame in m12 mode using arducalstill script. But the highest working mode is 10th. If I choose 12th or 11th mode I see standard application output and message “Start preview” after which application halts. I can’t save the frame in file either.
Hello, the firmware version you are using is not the same as mine. I have not tested it in Pi 3B+ platform. Can you try it on PI 3B platform. I will try the version you are using.
I have tested the firmware version on PI3B and it can work normally. I think it due to the 3B+ poor signal. Please try to set the line length to bigger. Please try to set 0x0162 t0 0x30 using the int arducam_write_sensor_reg(CAMERA_INSTANCE camera_instance, uint16_t address, uint16_t value); API
What I mean is that you can use the arducam_write_sensor_reg(CAMERA_INSTANCE camera_instance, uint16_t address, uint16_t value) API to configure the sensor’s line length. you can set the value to bigger to reduce the frame rate. In this way to reduce the pressure on the mipi interface data.