Hi,
I’ve followed the instructions on https://github.com/ArduCAM/MIPI_Camera/tree/master/RPI and I got no errors (but 2 warnings during compilation)
However, when I try ./arducamstill -?, I get this:
pi@raspberrypi:~/MIPI_Camera/RPI $ ./arducamstill -?
Open camera…
Hardware Platform: c03112
init camera status = 4100
in fact, all commands return this same result. I assume it does not init the camera properly for some reason.
The camera seems to be correctly attached and I2C is OK:
pi@raspberrypi:~/MIPI_Camera/RPI/utils $ ./camera_i2c
setting GPIO for board revsion: c03112
Raspberry Pi3B / Pi3B+ / 3A / 4B(1G/2G/4G)
Set state of 133 to 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: – – – – – – – – – – – – –
10: 10 – – – – – – – – – – – – – – –
20: – – – – – – – – – – – – – – – –
30: – – – – – – – – – – – – – – – –
40: – – – – – – – – – – – – – – – –
50: – – – – – – – – – – – – – – – –
60: 60 – – – – – – – – – – – – – – –
70: – – – – – – – –
Camera is OV9281, connected to RPi4 (4GB), 180MB GPU memory assigned.
Any ideas on how to proceed would be welcomed!
Thanks in advance.