Aducam Multi Camera Adapter V2.2 Does Not Connect Via I2C

Published by travin69 on

Home Forums Camera Breakout Boards Aducam Multi Camera Adapter V2.2 Does Not Connect Via I2C

Viewing 3 reply threads
  • Author
    Posts
    • #23712
      travin69
      Participant

      I have been trying for a day now to figure out how to get the Multi Camera Adapter to connect to my Pi 4B. I am using a V2.2 board. It is new as is the Pi 4b. All drivers are loaded from GitHub. Followed all instructions. Tried all trouble shooting I could find online. Board is connected properly and all ribbon cables have been checked installed properly and working (check cables with a single camera that was not connected to the adapter board). Any suggestions? I am rather new at this. Thanks in advance.

      Test i2c1

      Shows a 70 in spot 0 of row 70. That is all.

      Adapter board V2.1 configure OK

      v4l2 driver install OK

      Can’t find video0 device, please check the hardware connection.

      I am using the new Pi HQ 12MP cameras in slots A and C.

      Daniel

    • #23713
      travin69
      Participant

      Little bit of follow up:

      When trying the sudo ./init_camera.sh command in the terminal, I get the following  on the test i2c1:

      Line 10: 1a in the a column

      Line 60: 64 in the 4 column

      Line 70: 70 in the 0 column.

      Still fails to find video0 device.

      Regards,

      Daniel

    • #23799
      bin
      Keymaster

      Hello,

      Don’t worry. I will test it today and reply you as soon as possible.

       

    • #23800
      bin
      Keymaster

      Hello,

      I know the problem, For the new 12mp sensor, our firmware can’t support the new sensor id. So after detect each channel, it will open the fourth channel (D channel) default. So you should ensure you have connect a sensor to the camera D. You can connect the camera to A and D or C and D.

      Let me know if you need more help.

Viewing 3 reply threads
  • You must be logged in to reply to this topic.