1. Home
  2. Docs
  3. Camera breakout board
  4. 14MP MT9F001/MT9F002

14MP MT9F001/MT9F002

Introduction

Arducam MT9F001/MT9F002 camera breakout incorporates ON Semiconductor 1/2.3−inch CMOS active−pixel digital imaging sensor MT9F001/MT9F002 with an active pixel array of 4608 H × 3288 V (4640 H × 3320 V including border pixels). It can support 14−megapixel (4384 H × 3288 V) digital still images and a 1080p plus additional 20 percent pixels for electronic image stabilization (4608 H × 2592 V) in digital video mode.

Please note that it is the RAW sensor which doesn’t include ISP (Image Signal Processing) on the image sensor chip, so it only supports manual exposure, manual white balance, manual gain settings.

Key Specification

Optical format 1/2.3−inch (4:3)
Active pixels and imager size • 4608 H x 3288 V: (entire array): 6.451 mm (H) x 4.603mm (V), 7.925mm diagonal
• 4384 H x 3288 V (4:3, still mode): 6.138 mm (H) x 4.603 mm (V), 7.672 mm diagonal
• 4608 H x 2592 V (16:9, video mode): 6.451 mm
Pixel size 1.4 um x 1.4 um
Color filter array RGB Bayer pattern
ADC resolution 12−bit, on−chip
Responsivity 0.724 V/lux−sec (550 nm)
Dynamic range 65.3 dB
SNRMAX 35.5 dB
Frame Rate 14M resolution (4384H x 3288V):
Programmable up to 13.7 fps for HiSPi I/F, 6.3 fps for parallel I/F
Preview VGA mode
• 30 fps with binning
• 60 fps with skip2bin2
1080p mode:
• 60 fps using HiSPi interface 2304 H x 1296 V (1080p +20%EIS)
• 30 fps using parallel interface 2256 H x 1268 V (1080p +17%EIS)

Block Diagram

Application 

  • Digital video cameras 
  • Digital still cameras 
  • Industrial camera 
  • Medical camera 
  • Microscopy camera 
  • UAV camera

Order Information

Check the camera breakout from the product page.

Articles

Was this article helpful to you? Yes No