1. Home
  2. Docs
  3. Camera breakout board
  4. 13MP IMX135

13MP IMX135

Introduction

Arducam IMX135 camera breakout incorporates SONY 1/3−inch CMOS which adopts Exmor-R technology to achieve high-speed image capturing with high sensitivity and low noise performance. “RGBW coding” color filter is employed, and RGB primary color mosaic is reproduced on the chip. High sensitivity, low dark current, and smear-free features are achieved. It equips an electronic shutter with variable integration time.

Please note that it is the RAW sensor which doesn’t include ISP (Image Signal Processing) on the image sensor chip, so it only supports manual exposure, manual white balance, manual gain settings.

Key Specification

Optical format 1/3−inch
Active pixels 4208H x 3120V
Pixel size 1.12um x 1.12um
Color filter array RGB Bayer pattern
ADC resolution 10−bit, on−chip
Responsivity 0.62 V/lux−sec (545 nm)
Output Interface 2-Lane /4-Lane MIPI
Frame Rate 13 Mp full resolution at 24 fps
720p at 60 fps
1080 at 30 fps

Block Diagram

Application

  • Cellular phones
  • PDAs
  • Toys
  • Other battery-powered products
  • ARM/FPGA/DSP based platforms

Order Information

Check the camera breakout from the product page.

Articles

Was this article helpful to you? Yes No